Extra-Ordinary Maintenance Operations; Checking The Operation Of The Cardiotester Receiver; Checking The Operation Of The Hand Sensor Receiver; Checking The Working Conditions - Technogym Jog Now Excite+ 700 Service Maintenance Manual

JOG NOW Excite +: Service & maintenance manual - rev. 5.1

12.2. EXTRA-ORDINARY MAINTENANCE OPERATIONS

12.2.1. C
HECKING THE OPERATION OF THE CARDIOTESTER RECEIVER
1. Using a separate heart rate monitor, put on the transmitter band and check that the machine and
the separate monitor both measure the same heart rate, and that when the band is disconnected
the machine does not receive any signal.
2. Using a heart rate frequency simulator, check that the machine detects variations in the heart rat.
12.2.2. C
HECKING THE OPERATION OF THE HAND SENSOR RECEIVER
1. Using a separate heart rate monitor, grasp the hand sensors and check that the machine and the
separate monitor both measure the same heart rate, and that when the sensors are released the
machine does not receive any signal.
12.2.3. C
HECKING THE WORKING CONDITIONS
1. Check that the machine is connected directly to the wall outlet, without any extension cords, and
that the outlet is correctly earthed.
2. Using a multimeter, check that the machine earth node is correctly connected to earth.
12.2.4. C
HECKING THE STATE OF WEAR OF TREAD BELT AND RUNNING DECK
1. Disassemble the rear and driving rollers, the running deck and the tread belt.
2. Check the state of wear of both the running deck and the tread belt. Replace if there are evident
signs of wear.
3. Using a clean cloth, wipe the entire surface of the running deck and the underside of the tread
belt.
12.2.5. C
HECKING THE WEAR OF THE MOTOR ROLLER
1. With the rear and driving rollers, running deck and tread belt disassembled, check the state of
wear of the driving roller. Replace if there are evident signs of wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
12.2.6. C
HECKING THE STATE OF WEAR OF THE DRIVING ROLLER
1. With the front and rear rollers, running deck and tread belt disassembled, check the state of wear
of the rear roller. Replace if there are evident signs of wear.
2. With the machine in motion, check the noisiness of the bearings. Replace in the event of
excessive noise.
12.2.7. C
HECKING THE SHOCK ABSORBERS
1. With the front and rear rollers, running deck and tread belt disassembled, check the condition of
the shock absorbers on either side of the running deck. Replace if they are cracked or show signs
of breakage.
Pagina 12.3