Figure 7.21-8
10. Slip off with caution the cable from the frame, in direction of the yellow arrow, as shown in the
figure at the side.
11. Remove the autotransformer (i) with caution.
WARNING: Pay particular attention during the moving of the autotransformer,
because it is extremely fragile, also a little hit, can damage it.
To reassemble the autotransformer, carry out the above steps in reverse order; following the note
Page 7.42
JOG NOW Excite +: Service & maintenance manual - rev. 5.1
9. Back off the 2 screws (h) using a 5mm
hexagonal wrench.
For reasons of space, for the 2 lower
screws is recommended to use a ratchet
wrench.
Figure 7.21-9
reported above:
Continued on following page...