Service Maintenance - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 4 INSTALLATION & MAINTENANCE

2. Service Maintenance

A list is shown below. For details of replacement parts, refer to the above section, "II. PARTS
REPLACEMENT".
No. Location/parts
1 Platen roller
2 Other rollers
Bearing
3 Magnetic clutch
4 One-way gear
Shaft
5 CIS unit
6 Frame LED PCB
7 Ink drain pad
8 Parts to which ink
is attached
(Post-imprinter)
Note 1: If rollers or feed paths are very dirty, the user should be advised to perform "user
maintenance".
Note 2: If necessary, make a request to replace the roller of the exchange roller kit.
Note 3: If the power cord connection gathers dust, it may result in electrical leak. Clean it as
required.
4-22
Intervals
3,000,000 6,000,000
sheets sheets
: During above replacement
Table 4-302
COPYRIGHT © CANON ELECTRONICS INC. 2008
[ : Cleaning,
8,000,000
sheets
If much paper powder occurs,
the intervals shorten.
Fully open the upper unit and
clean the rear feed path. Do
not get your hand caught.
: Adjust, : Replace]
Remarks
CANON DR-X10C FIRST EDITION