Canon imageFORMULA DR-X10C Service Manual page 133

5) Remove the cable and screw (M3 round
tip) and remove the PCB
2 .
Figure 3-1004
1) Remove the ink drain pad unit after re-
moving the rear cover. Remove 2 screws
(M3, round tip) and remove the ink
1
drain pad unit
2
Note: If ink is collected in the pad, provide
paper and a storage bag to prevent
soiling of your fingers or the periphery.
Figure 3-1005
COPYRIGHT © CANON ELECTRONICS INC. 2008
1 and motor
.
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
Notes on assembling
Fit the belt 2 into the fitting parts
the cartridge holder.
Insert the projection of the end surface (the
opposite side of the end surface of the
D-shape) of the guide shaft into the hole in
the mounting plate.
Figure 3-1006
1 of
3-63