Base Unit-2 (Feed System); Entrance Lower Guide Unit; Platen Roller (Lower) - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY
IV. BASE UNIT-2 (FEED SYSTEM)

1. Entrance Lower Guide Unit

1) Remove the retard roller.
(Page 3-2)
2) Remove screw 1
while unhooking 2 pairs of the fitting parts
, remove the cover
2
remove the cover on the opposite side.
Note: A light guide for the sensor is built in the
right cover.
Figure 3-401
3) Remove 3 screws
remove the entrance lower guide unit
Figure 3-402
3-24
(M3, round tips), and
. In the same way,
3
1 (short stepped) and
2
COPYRIGHT © CANON ELECTRONICS INC. 2008

2. Platen Roller (Lower)

1) Remove 2 screws
ing a short screwdriver, lift the front of the
guide plate
pairs of the rear fitting parts
the guide plate.
Note: If no short screwdriver is available,
remove the upper unit.
2) Lower the front of the platen roller
it, align the positions of both bearings
.
and pull it out upward.
Notes on assembling
Insert the fitting parts of the guide plate
below the fitting parts of the platen roller.
1 (M3, round tip) us-
2 , and while unhooking 2
3 , remove
Figure 3-403
Figure 3-404
CANON DR-X10C FIRST EDITION
, turn
1
2