Canon imageFORMULA DR-X10C Service Manual page 184

CHAPTER 5 TROUBLESHOOTING
h. Imprinter
The operation check of the imprinter is
performed in this mode. When the [Im-
printer] tab is selected, a screen is dis-
played. The screen on the imprinter side
that is not connected is grayed out.
The figure below shows the post-imprinter
screen.
Figure 5-325
1) Head Position
The cartridge unit is moved in this mode.
When the stop position is selected and
then the [Move] button is pressed, the
cartridge unit is moved.
Figure 5-326
Note: If actual operation is checked visually,
remove the eject tray unit and set the
imprinter door sensor in the detection
state using paper, etc.
5-22
2) Flush
The ink is ejected in this mode. If a sheet of
paper is set in the machine to check the
ejection of ink, a paper jam error occurs or
the paper is ejected automatically. If the
ejection is checked, set the paper so that it
does not touch the roller or sensor.
The operation procedure is shown below.
Operation Procedure
i) Set the cartridge unit position at the left
end (0mm) or the second position.
ii) Set a sheet of paper with a width (approx.
100 mm) which does not touch the roller
at the left end so that the paper is posi-
tioned at the ink ejection position.
iii) Close the upper unit and select the [Start]
button.
iv) Visually check whether ink is ejected.
Note: The value shown on the right side of the
[Start] button is the number of ejections
and cannot be changed.
COPYRIGHT © CANON ELECTRONICS INC. 2008
Figure 5-327
CANON DR-X10C FIRST EDITION