Pre-Imprinter - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

2. Pre-Imprinter

2) Remove the eject tray unit.
(Page 3-10)
3) Remove the cable
Figure 3-1007
4) Remove the entrance upper unit.
(Page 3-40)
5) Remove the reading roller (front).
(Page 3-52)
6) Remove 3 screws
remove the pre-imprinter
main body.
Note: Remove the ink cartridge beforehand.
Figure 3-1008
3-64
1 for the pre-imprinter.
1 (M3, round tip) and
from the
2
COPYRIGHT © CANON ELECTRONICS INC. 2008
7) Remove the stop ring
guide shaft 2 from the cartridge holder
3 . Pull out the belt mounted on the rear
side of the cartridge holder.
Figure 3-1009
8) Remove the cable
and connector and remove the cartridge
holder 2 .
Figure 3-1010
1 and remove the
1 from the cable holder
CANON DR-X10C FIRST EDITION