Post-Imprinter; X. Option - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

X. OPTION

Note: This section describes the pre-imprinter
and post-imprinter. Since the patchcode
decoder consists of a PCB and a few of
parts only, the entire product must be
replaced.

1. Post-Imprinter

1) Remove the eject tray unit.
(Page 3-10)
2) Remove the cable
round tip) and remove the post-imprinter
from the main body.
Note: Remove the ink cartridge beforehand.
Figure 3-1001
3-62
and screw (M3,
1 2
COPYRIGHT © CANON ELECTRONICS INC. 2008
3) Remove the screw
remove the guide shaft
tridge holder 3 . Pull out the belt mounted
on the rear side of the cartridge holder.
Figure 3-1002
4) Remove the cable
and connector and remove the cartridge
holder 2 .
Figure 3-1003
1 (M3, round tip) and
2 from the car-
1 of the cable holder
CANON DR-X10C FIRST EDITION