VIII. UPPER UNIT-3 (FEED SYSTEM)
1. Platen Roller
1) Remove the screws
sides. Then, rotate the platen roller
the direction of the arrow, align the bearing
3
with the side plate notch
move the platen roller.
Figure 3-801
COPYRIGHT © CANON ELECTRONICS INC. 2008
1
(stepped) on both
2
in
4
, and re-
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
2. Registration Roller
1) Remove the entrance upper unit.
(Page 3-40)
2) Open the ends (marked with
bearing holders
parts and remove the registration roller unit
.
2
Note: Since the coil spring in the registration
roller unit may be detached, do not lose
it.
Note: Since the entire registration roller unit
and a single registration roller are set as
service parts, select them as required.
Figure 3-802
) of both
1
and unhook the fitting
3-51