Reading Roller (Rear); U-Turn Roller A - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

6. Reading Roller (Rear)

1) Remove the right and left covers.
(Page 3-3), (Page 3-5)
2) Remove the platen roller (lower).
(Page 3-24)
3) Remove the control PCB.
(Page 3-13)
4) Remove the belt
fitting parts 2 and remove the gear
and pin.
Note: Do not drop and lose the pin.
Figure 3-411
5) Remove the stop ring
moving the ball bearings
remove the reading roller (rear)
Figure 3-412
3-28
1 . Unhook 2 pairs of the
1 , and while re-
2 on both sides,
3 .
COPYRIGHT © CANON ELECTRONICS INC. 2008

7. U-Turn Roller A

1) Remove the right and left covers.
(Page 3-3), (Page 3-5)
2) Remove the control PCB.
(Page 3-13)
3) Remove the belts
hook 2 pairs of the fitting parts
remove the gear
3 Remove the parts on the opposite side in
the same way, and remove the U-turn
roller A 4
Note: Do not drop and lose the pin.
1 on both sides. Un-
3 , pin and bearing.
from the rear cover side.
Figure 3-413
CANON DR-X10C FIRST EDITION
2 and