Canon imageFORMULA DR-X10C Service Manual page 135

9) Remove the cable and 2 screws
round tip) and remove the motor
Figure 3-1011
10) Remove the cable and 2 screws
(M3, round tip) and remove the PCB
Figure 3-1012
Absorbing pad
The ink drain pad for the pre-imprinter is
located in the frame detection unit. Refer to
the "Frame Detection Unit" section for the
details.
(Page 3-39)
COPYRIGHT © CANON ELECTRONICS INC. 2008
1 (M3,
2 .
1
.
2
CANON DR-X10C FIRST EDITION
CHAPTER 3 DISASSEMBLY & REASSEMBLY
Notes on assembling
Fit the belt 2 into the fitting parts
the cartridge holder.
Insert the projection of the end surface (the
opposite side of the end surface of the
D-shape) of the guide shaft into the hole in
the mounting plate.
Figure 3-1013
1 of
3-65