Canon imageFORMULA DR-X10C Service Manual page 182

CHAPTER 5 TROUBLESHOOTING
f. Feed Test
Paper can be actually fed in this mode
among service modes. However, a sheet
of paper can be fed manually and other
conditions cannot be selected, but the
operation of sensors during feeding can
be checked.
The operation procedure is shown below.
1) Select the [Feed Test] button on the lower
right of the screen.
2) The pickup tray lifts and each roller ro-
tates.
3) Insert a sheet of paper at a time into the
pickup inlet.
4) The paper is fed and ejected onto the
eject tray.
5) When the [Feed Test] button is selected
again, the test stops.
An example of the sensor display section
during feeding is shown below.
Figure 5-318
5-20
g. ImgFrame
The operation check of the frame detection
unit is performed in this mode. When the
[ImgFrame] tab is selected, a screen is
displayed.
1) Edge Buffer
Paper is actually fed and data of its outside
frame is obtained in this mode and the
shape is displayed in the display section.
The operation procedure is shown below.
Operation Procedure
i) When [Renew] is selected, [Speed] be-
comes effective, so select [High] or
[Low].
ii) Set a sheet of paper on the pickup tray
and select the [Read] button.
iii) The paper is automatically fed and
ejected onto the eject tray.
COPYRIGHT © CANON ELECTRONICS INC. 2008
Outside frame display
Figure 5-319
Figure 5-320
CANON DR-X10C FIRST EDITION