Canon imageFORMULA DR-X10C Service Manual page 74

CHAPTER 3 DISASSEMBLY & REASSEMBLY
4) Move the pickup tray upward and remove
the screw 1 (round tip).
Figure 3-204
5) Unhook the rear fitting part
lifting the main body a little to raise the
tip-resistant foot
cover from the main body.
3
Note: Do not pull it excessively because a
cable is connected to the back side.
Figure 3-205
3-4
1 , and while
2 , remove the right
COPYRIGHT © CANON ELECTRONICS INC. 2008
6) Remove the cable
right cover 2 .
Figure 3-206
7) Remove the operation panel if necessary.
(Page 3-12)
Notes on assembling
To close the pickup tray, first move it
downward and then close it.
The screw (for operation panel installation)
in step 4 is not self-tapping screw, but
normal type.
1 and remove the
CANON DR-X10C FIRST EDITION