Cis Unit - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY
4) While holding the motor with hand, slide
the slide plate slightly to the right and left.
Verify that the end
shaft turns.
Note: To confirm rotation, a mark
affixed to the end surface of the rotating
shaft.
Figure 3-514
5) If it turns, the position is correct. In this
condition, fix the motor with screws.
Note: If it does not turn, retry assembly.
3-36
1 of the motor rotating
2 may be
COPYRIGHT © CANON ELECTRONICS INC. 2008

4. CIS Unit

1) Remove the shading motor.
(Page 3-35)
2) Unhook 2 pairs of the fitting parts
remove the cover
slide plate 3 by aligning positions.
Figure 3-515
3) Remove the shaft guide ring
tweezers.
Figure 3-516
1 and
2 . Then, remove the
with
1
CANON DR-X10C FIRST EDITION