Power Supply Pcb - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY

2. Power Supply PCB

1) Remove the rear cover.
(Page 3-3)
2) Remove 3 screws
washer) and pull out the panel
Note: Do not pull it excessively because a
cable is connected to the back side.
Figure 3-304
3) Remove 4 cables
power supply PCB
Note: The connector marked with
Figure 3-305
3-14
1 (with a tooth
2 .
1 and remove the
2 (with a panel).
has a lock.
COPYRIGHT © CANON ELECTRONICS INC. 2008
4) Remove 4 screws
move the power supply PCB
Figure 3-306
Notes on assembling
There is no electrical problem if 4-pole
connector of the DC power supply cable is
connected to either of the 2 4-pole con-
nectors (CN1, CN3) on the power supply
PCB, but it must be connected to CN1.
When pushing the power supply PCB (with
a panel) into the main body, align the lock
screw hole positions roughly since there
are 3 positioning guides in the main body.
1 (round tip) and re-
2 .
CANON DR-X10C FIRST EDITION