Upper Unit-1 (External Covers); Entrance Upper Unit; Pickup Roller Cover - Canon imageFORMULA DR-X10C Service Manual

CHAPTER 3 DISASSEMBLY & REASSEMBLY
VI. UPPER UNIT-1 (EXTERNAL COVERS)

1. Entrance Upper Unit

1) Open the pickup roller cover.
2) Press the rear side
both arms and unhook the fitting parts in-
side. The pickup roller cover opens further.
Figure 3-601
3) While holding the entrance upper guide
plate , remove 9 screws
1
tip) and remove the entrance upper unit
.
3
Note: The screws at the lower 2 places
(marked with
Remove the screws with a magnetized
screwdriver so that they do not drop
inside.
Figure 3-602
3-40
1 (marked with ) of
(M3, round
2
) are hidden inside.
COPYRIGHT © CANON ELECTRONICS INC. 2008

2. Pickup Roller Cover

1) Remove the entrance upper unit.
(Page 3-40)
2) While bending the stopper
end of the shaft
tip and unhook the fitting parts. Then re-
move the shaft.
When the shaft is removed, the entrance
upper guide plate
cover are separated.
4
Figure 3-603
1 , push the
2 with a tool with a thin
and pickup roller
3
CANON DR-X10C FIRST EDITION