Canon imageFORMULA DR-X10C Service Manual page 104

CHAPTER 3 DISASSEMBLY & REASSEMBLY
4) Remove 2 screws
self-tapping) and turn the reading PCB
over.
Note: Do not pull it excessively because the
cables are connected to it.
Figure 3-508
5) Pull out both ends of the lock plate of the
connector 1 using the clips
move the flat cable
remove the flat cable on the opposite side.
Figure 3-509
3-34
1 (M3, TP head,
2
2 and re-
3 . In the same way,
COPYRIGHT © CANON ELECTRONICS INC. 2008
Notes on assembling
When the lock plate of the connector is
open, insert the flat cable into the con-
nector until the contact surface of the flat
cable is entirely covered and then close
the lock plate.
When assembling the PCB in the case,
align the end surface of the PCB with the
end surface of the sponge of the case and
press it. The PCB must not ride on the
sponge.
CANON DR-X10C FIRST EDITION