Scsi Transfer; Counter - Canon imageFORMULA DR-X10C Service Manual

13. SCSI Transfer

This mode is used to change the
maximum value of the synchronizing trans-
fer speed of the SCSI interface.
However, there is normally no problem
with the factory setting (20 MB/sec), so the
setting should be changed only if the ma-
chine does not work properly. It can also be
changed in the user mode.
When [SCSI Transfer] is selected on the
service screen, a setting screen is displayed.
Change the setting as required and press
the [OK] button.
Then, a confirmation screen is displayed,
so select the [OK] button again.
Figure 5-333
COPYRIGHT © CANON ELECTRONICS INC. 2008

14. Counter

of sheets fed and document jams and record
the number of sheets fed when replacing
consumable parts. These values can be
changed.
the service screen, the [Change Counter]
screen is displayed. The figure below shows a
list of items on each screen and the [Change
Counter] screen.
lower part of the service screen.
CANON DR-X10C FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
This mode is used to confirm the number
When the [Counter] button is selected on
The [Total Count] value is displayed at the
Figure 5-334
5-25