Scanner Is Not Recognized - Canon imageFORMULA DR-X10C Service Manual

2. Scanner Is Not Recognized

Note: Install the driver in the computer before connecting the scanner.
Cause/faulty
location
Power supply
Connection of IF
interface cable
Power-on
sequence
(SCSI connection)
SCSI ID settings
Computer, I/F card
COPYRIGHT © CANON ELECTRONICS INC. 2008
Step Check item
1 Is the power supplied to this
machine?
2 Is the IF interface cable prop-
erly connected?
3 Was the power to this machine
turned ON before the com-
puter was turned ON in the
case of the SCSI connection?
4 Is the SCSI ID set properly?
5 Are the computer and I/F card
set properly?
Table 5-502
CANON DR-X10C FIRST EDITION
CHAPTER 5 TROUBLESHOOTING
Result Action
NO Perform the actions in
section 1: "No power is
supplied".
NO Connect it properly.
NO Follow the proper power-on
sequence.
NO Set them properly.
NO Use them properly.
5-29