Parameter Settings; Settings On The Master Station (Rj71En71) - Mitsubishi Electric NZ2FTGN User Manual

11.6

Parameter Settings

This section describes the parameters to be set for the master station (RJ71EN71 or QJ71MT91) and slave station (NZ2FT-
MT and I/O module).

Settings on the master station (RJ71EN71)

Use GX Works3 to set automatic communication (constant periodic communication) using the simple CPU communication
function among the MODBUS/TCP master functions.
 MELSEC iQ-R Ethernet User's Manual (Application)
This section describes the case where the RJ71EN71 is the master station and the NZ2FT-MT and I/O module are the slave
stations.
Basic settings
Set the communication parameters of the RJ71EN71 in "Basic Settings" of GX Works3.
[Navigation window]  [Parameter]  [Module Information]  [RJ71EN71(E+E)]  [Module Parameter (Ethernet)]
Item
IP address IP address
setting
Subnet mask
Default gateway
Simple CPU communication settings
Set the communication settings with NZ2FT-MT in "Simple PLC Communication Setting" in "Application Settings".
Set "To Use or Not to Use Simple PLC Communication" to "Use" and click the [Detailed Setting] tab of "Simple PLC
Communication Setting" to display the following window.
Item Description
Communication Set whether to read or write the NZ2FT-MT data.
Pattern
Communication Set the data communication method.
Setting: Execution • Fixed Interval: Data is sent and received at the specified execution interval (ms).
Interval (ms) • On Request: Data is sent and received only once on request. (Operation when communication setting is requested  MELSEC iQ-R
Ethernet User's Manual (Application))
Description
Set the IP address of the RJ71EN71.
Set the subnet mask of the RJ71EN71.
Set the default gateway of the RJ71EN71.
11 NZ2FT-MT
299
11.6 Parameter Settings
11