Danfoss VLT Midi Drive FC 280 Programming Manual page 76

Parameter Descriptions
8-56 Preset Reference Select
Option:
[0] Digital
input
[1] Bus
4 4
[2] Logic AND
[3] Logic OR
*
8-57 Profidrive OFF2 Select
Select control of the frequency converter OFF2 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word and parameter 8-10 Control Word Profile is set to [1]
Profidrive profile.
Option:
[0]
[1]
[2]
[3]
*
8-58 Profidrive OFF3 Select
Select control of the frequency converter OFF3 selection via the
terminals (digital input) and/or via the fieldbus. This parameter is
active only when parameter 8-01 Control Site is set to [0] Digital
and ctrl. word, and parameter 8-10 Control Word Profile is set to [1]
Profidrive profile.
Option:
[0]
[1]
[2]
[3]
*
8-79 Protocol Firmware version
Range:
Size related
*
8-80 Bus Message Count
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
74
Function:
Select the trigger for the preset reference
selection.
A digital input triggers the preset reference
selection.
A serial communication port or the fieldbus
triggers the preset reference selection.
The fieldbus/serial communication port and a
digital input trigger the preset reference
selection.
The fieldbus/serial communication port or a
digital input triggers the preset reference
selection.
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
Digital input
Bus
Logic AND
Logic OR
Function:
[0 - 65535 ] Firmware revision: FC is in index 0;
Modbus is in index 1; indexes 2–4
are reserved.
Function:
valid telegrams detected on the bus.
Danfoss A/S © 07/2016 All rights reserved.
®
VLT Midi Drive FC 280
8-81 Bus Error Count
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
8-82 Slave Messages Rcvd
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
8-83 Slave Error Count
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
8-84 Slave Messages Sent
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
8-85 Slave Timeout Errors
Range:
0 [0 - 4294967295 ] This parameter shows the number of
*
8-88 Reset FC port Diagnostics
Reset all FC port diagnostic counters.
Option:
[0]
*
[1]
8-90 Bus Jog 1 Speed
Range:
100 RPM
8-91 Bus Jog 2 Speed
Range:
200 RPM
Function:
telegrams with faults (for example CRC
faults) detected on the bus.
Function:
valid telegrams sent by the frequency
converter to the slave.
Function:
error telegrams, which could not be
executed by the frequency converter.
Function:
messages sent from the slave.
Function:
slave timeout errors.
Do not reset
Reset counter
Function:
[ 0 - 1500 Enter the jog speed. This is a fixed
*
RPM] jog speed activated via the serial
port or fieldbus option.
Function:
[ 0 - 1500 Enter the jog speed. This value is a
*
RPM] fixed jog speed activated via the
serial port or fieldbus option.
Function:
MG07C302