Danfoss VLT Midi Drive FC 280 Programming Manual page 52

Parameter Descriptions
4-21 Speed Limit Factor Source
Select an analog input for scaling the settings in
parameter 4-19 Max Output Frequency 0–100% (or inverse). The
signal levels corresponding to 0% and 100% are defined in the
analog input scaling, for example parameter group 6-1* Analog
Input 1. This parameter is only active when
parameter 1-00 Configuration Mode is in torque mode.
Option:
4 4
[4]
[6]
[8]
4-22 Break Away Boost
Option: Function:
[0] Off
*
[1] On The frequency converter provides higher current than
normal current levels to enhance breakaway-torque
capacity.
4-30 Motor Feedback Loss Function
Option:
[0] Disabled
*
[1] Warning
[2] Trip
[3] Jog
[4] Freeze
Output
[5] Max Speed
[6] Switch to
Open Loop
4-31 Motor Feedback Speed Error
Range:
20 Hz [0 - 50 Hz] Select the maximum allowed error in speed
*
50
VLT
Function:
Analog in 53 inv
Analog in 54
Analog in 54 inv
Function:
This function is used to monitor consistency
in the feedback signal, that is, if the feedback
signal is available. Select the action of the
frequency converter if a feedback fault is
detected. The selected action takes place
when the feedback signal differs from the
output speed by the value set in
parameter 4-31 Motor Feedback Speed Error
for longer than the value set in
parameter 4-32 Motor Feedback Loss Timeout.
Function:
(output speed versus feedback).
Danfoss A/S © 07/2016 All rights reserved.
®
Midi Drive FC 280
Speed
[rpm]
Illustration 4.8 Motor Feedback Speed Error
4-32 Motor Feedback Loss Timeout
Range:
0.05 s [0 - 60
*
s]
4-40 Warning Freq. Low
Range:
Size
related 500
*
Hz]
4-41 Warning Freq. High
Range:
Size
related 500
*
Hz]
4-42 Adjustable Temperature Warning
Range:
0 [ 0 - 255 ] Use this parameter to set the motor temperature
*
n
calc
n
actual
P 4-31
P 4-32
Function:
Set the timeout value allowing the speed
error set in parameter 4-31 Motor Feedback
Speed Error to be exceeded before enabling
the function selected in parameter 4-30 Motor
Feedback Loss Function.
Function:
[ 0 - Use this parameter for setting a lower limit
for the frequency range. When the motor
speed drops below this limit, the display
reads Speed low. Warning bit 10 is set in
parameter 16-94 Ext. Status Word. Output relay
can be configured to indicate this warning.
LCP warning light is not lit when the limit set
is reached.
Function:
[ 0 - Use this parameter for setting a higher limit
for the frequency range. When the motor
speed exceeds this limit, the display reads
Speed high. Warning bit 9 is set in
parameter 16-94 Ext. Status Word. Output relay
can be configured to indicate this warning.
LCP warning light is not lit when the limit set
is reached.
Function:
limit.
Time
[sec]
MG07C302