Danfoss VLT Midi Drive FC 280 Programming Manual page 32

Parameter Descriptions
0-38 Display Text 2
Range:
[0 - 0 ] Free text, for example used for the location tag of
fieldbus application.
0-39 Display Text 3
Range:
[0 - 0 ] Free text, for example used for the help tag of
4 4
fieldbus application.
0-40 [Hand on] Key on LCP
Option:
[0] Disabled Avoid accidental start of the frequency converter
[1] Enabled [Hand On] is enabled.
*
0-42 [Auto on] Key on LCP
Option:
[0] Disabled Avoid accidental start of the freqeuncy converter
[1] Enabled [Auto On] is enabled.
*
0-44 [Off/Reset] Key on LCP
Option:
[0] Disabled
[1] Enabled
*
[7] Enable Reset Only
0-50 LCP Copy
Option:
[0] No copy
*
[1] All to LCP
[2] All from
LCP
[3] Size indep.
from LCP
0-51 Set-up Copy
Use this parameter to copy parameters between set-ups.
Option:
[0] No copy
*
[1] Copy from setup 1
[2] Copy from setup 2
[3] Copy from setup 3
[4] Copy from setup 4
[9] Copy from Factory setup
30
Function:
Function:
Function:
in hand-on mode.
Function:
from LCP.
Function:
Function:
No function.
Copy all parameters in all set-ups from the
frequency converter memory to the LCP. For
service purposes, copy all parameters to the
LCP after commissioning.
Copy all parameters in all set-ups from the LCP
memory to the frequency converter memory.
Copy only the parameters that are
independent of the motor size. This selection
can be used to program several frequency
converters with the same function without
disturbing motor data that is already set.
Danfoss A/S © 07/2016 All rights reserved.
®
VLT Midi Drive FC 280
Function:
MG07C302