Danfoss VLT Midi Drive FC 280 Programming Manual page 135

Index
Motor
Current................................................................................................. 21
Data................................................................................................ 20, 22
High back EMF................................................................................ 131
control principle............................................................................... 31
current................................................................................. 18, 32, 130
data........................................................................................... 127, 130
magnetization at 0 speed............................................................. 35
pole....................................................................................................... 34
power.......................................................................................... 18, 130
rotating............................................................................................. 131
speed direction................................................................................. 49
thermal protection............................................................................. 4
voltage................................................................................................. 32
N
Navigation key................................................................................ 12, 18
Nominal motor speed......................................................................... 32
Numeric display.................................................................................... 12
O
Operating mode................................................................................... 23
Operation key................................................................................. 12, 18
Output current.................................................................................... 127
Overheating......................................................................................... 127
Overtemperature............................................................................... 127
P
Phase loss.............................................................................................. 127
Potentiometer reference...................................................................... 9
Power cycle............................................................................................... 6
Preset reference.................................................................................... 44
Programming......................................................................... 18, 19, 127
Pulse input.............................................................................................. 60
Pulse reference......................................................................................... 5
Q
Qualified personnel............................................................................. 10
Quick menu..................................................................................... 14, 18
R
Rated motor current.............................................................................. 4
Rated motor speed................................................................................. 4
RCD............................................................................................................... 6
Reference................................................................................................. 18
Relay configuration.............................................................................. 57
Reset......................................................................... 18, 19, 20, 127, 130
Rotor resistance..................................................................................... 34
MG07C302
Programming Guide
S
Safety........................................................................................................ 11
Serial bus............................................................................................... 122
Serial communication.................................................................... 5, 19
Short circuit.......................................................................................... 128
SIL2............................................................................................................... 4
SILCL of SIL2.............................................................................................. 4
Sleep speed [Hz]................................................................................... 95
Slip compensation.................................................................................. 6
Standard and compliance for STO.................................................... 4
Start delay............................................................................................... 37
Start/stop................................................................................................... 8
Start-up.................................................................................................... 20
Stator leakage reactance............................................................ 33, 34
Stator resistance.................................................................................... 34
Supply voltage.................................................................................... 129
Synchronous motor speed.................................................................. 4
T
Terminal 42
Terminal 42 mode............................................................................ 63
Terminal 53
Terminal 53 filter time constant.................................................. 62
Terminal 53 high voltage.............................................................. 62
Terminal 53 low voltage................................................................ 62
Terminal 54
Terminal 54 filter time constant.................................................. 63
Terminal 54 high current............................................................... 63
Terminal 54 high voltage.............................................................. 63
Terminal 54 low current................................................................. 63
Terminal 54 low voltage................................................................ 63
Terminal 54 mode............................................................................ 63
Terminals
Control terminal...................................................................... 19, 125
Input terminal................................................................................. 127
Thermal load................................................................................... 35, 90
Thermal protection................................................................................ 4
Thermistor................................................................................................. 6
Torque
Torque................................................................................................ 127
Torque [%]............................................................................................... 90
Trip................................................................................................................ 6
Trip condition...................................................................................... 122
Trip lock................................................................................................. 122
U
Unintended start........................................................................... 10, 83
Danfoss A/S © 07/2016 All rights reserved. 133