Danfoss VLT Midi Drive FC 280 Programming Manual page 103

Parameter Descriptions
37-13 Pos. PID Output Clamp
Range: Function:
1000 [1 - This parameter clamps the total output of
*
10000 ] the PID. A setting of 1000 corresponds to
100% of parameter 32-80 Maximum Allowed
Velocity.
37-14 Pos. Ctrl. Source
Select the control source for positioning control.
Option:
[0] DI
*
[1] FieldBus
37-15 Pos. Direction Block
Use this parameter to configure whether to block a direction,
and the direction to be blocked.
Option:
[0] No Blocking
*
[1] Block Reverse
[2] Block Forward
37-17 Pos. Ctrl Fault Behaviour
This parameter determines the behavior of the frequency
converter after a fault is detected.
Option:
[0] Ramp Down&Brake
*
[1] Brake Directly
37-18 Pos. Ctrl Fault Reason
READ-ONLY PARAMETER: The current fault reason of the alarm.
POSITION CTRL FAULT is shown in this parameter.
Option:
[0] No Fault
*
[1] Homing Needed
[2] Pos. HW Limit
[3] Neg. HW Limit
[4] Pos. SW Limit
[5] Neg. SW Limit
[7] Brake Wear Limit
[8] Quick Stop
[9] PID Error Too Big
[12] Rev. Operation
[13] Fwd. Operation
[20] Can not find home position
37-19 Pos. New Index
Range: Function:
0 [0 - 255 ] The currently latched index number.
*
MG07C302
Programming Guide
Function:
Function:
Function:
Function:
Danfoss A/S © 07/2016 All rights reserved.
4 4
101