Operation Keys And Indicator Lights (Leds); The Right-Key Function On Nlcp - Danfoss VLT Midi Drive FC 280 Programming Manual

Programming
Key
For moving to the previous step or layer
9 [Back]
in the navigation structure.
For switching between parameter groups,
parameters, and within parameters, or
▲ ▼
10 [ ] [ ] increasing/decreasing parameter values.
Arrows can also be used for setting local
reference.
Press to access parameter groups or to
11 [OK]
enable a selection.
Press to move from left to right within
12 the parameter value to change each digit
[►]
individually.
Table 3.3 Legend to Illustration 3.1, Navigation Keys
D. Operation keys and indicator lights (LEDs)
Key
Starts the frequency converter in local control.
•
An external stop signal by control input or
13 Hand On
serial communication overrides the local
hand on.
Stops the motor but does not remove power
to the frequency converter or resets the
14 Off/Reset
frequency converter manually after a fault has
been cleared.
Puts the system in remote operational mode.
•
Responds to an external start command by
15 Auto On
control terminals or serial communication.
Table 3.4 Legend to Illustration 3.1, Section D
WARNING
ELECTRICAL HAZARD
Even after pressing the [Off/Reset] key, voltage is present
at the terminals of the frequency converter. Pressing the
[Off/Reset] key does not disconnect the frequency
converter from mains. Touching live parts can result in
death or serious injury.
•
Do not touch any live parts.
MG07C302
Programming Guide
Function
Function
Danfoss A/S © 07/2016 All rights reserved.

3.1.2 The Right-key Function on NLCP

Press [►] to edit any of the 4 digits on the display
individually. When pressing [►] once, the cursor moves to
the first digit, and the digit starts flashing as shown in
▲ ▼
Illustration 3.3. Press the [ ] [
Pressing [►] does not change the value of the digits, or
move the decimal point.
Setup 1
Setup 1
Setup 1
Setup 1
Setup 1
Illustration 3.3 Right-key Function
[►] can also be used for moving between parameter
groups. When in Main Menu, press [►] to move to the first
parameter in the next parameter group (for example, move
from parameter 0-03 Regional Settings [0] International to
parameter 1-00 Configuration Mode [0] Open loop).
NOTICE
During start-up, the NLCP shows the message LCP ON.
When this message is no longer shown, the frequency
converter is ready for operation. Adding or removing
options can extend the duration of start-up.
] to change the value.
13
3 3