Show System Switchover - Dell PowerConnect J-EX4200-24T Software Manual

Dell PowerConnect J-Series Ethernet Switch Complete Software Guide for Junos OS

show system switchover

Syntax
Release Information
Description
Options
Required Privilege
Level
List of Sample Output
Output Fields
Table 38: show system switchover Output Fields
Field Name Field Description
Display graceful Routing Engine switchover status:
Graceful switchover
State of the configuration database:
Configuration database
State of the kernel database:
Kernel database
260
show system switchover
Command introduced before Junos OS Release 10.2 for J-EX Series switches.
Display whether graceful Routing Engine switchover is configured, the state of the kernel
replication (ready or synchronizing), any replication errors, and whether the primary and
standby Routing Engines are using compatible versions of the kernel database.
NOTE: Issue the
Routing Engine. This command is not supported on the master Routing Engine.
because the
kernel-replication
Routing Engine. This process runs only on the backup Routing Engine.
view
show system switchover (Backup Routing Engine) on page 261
Table 38 on page 260 describes the output fields for the
Output fields are listed in the approximate order in which they appear.
—Indicates
On graceful-switchover
Off —Indicates graceful-switchover
—Configuration database has synchronized.
Ready
Synchronizing —Configuration database is synchronizing. Displayed when there are updates within
the last 5 seconds.
Synchronize failed —Configuration database synchronize process failed.
Ready —Kernel database has synchronized.
—Kernel database is synchronizing. Displayed when there are updates within the last
Synchronizing
5 seconds.
—The primary and standby Routing Engines are running incompatible kernel
Version incompatible
database versions.
—An error occurred when the state was replicated from the primary Routing Engine.
Replication error
Inspect /var/log/ksyncd for possible causes, or notify Dell Support (see "Requesting Technical
Support" on page lxxi).
show system switchover command only on the backup
process daemon does not run on the master
is specified for the
routing-options
is not specified for the routing-options
show system switchover command.
configuration command.
configuration command.