Connecting And Configuring A J-Ex Series Switch (J-Web Procedure) - Dell PowerConnect J-EX4200-24T Software Manual

J series; j-ex series
Table of Contents

Advertisement

Related
Documentation

Connecting and Configuring a J-EX Series Switch (J-Web Procedure)

The configuration is committed as the active configuration for the switch. You can now
log in with the CLI or the J-Web interface to continue configuring the switch. If you use
the J-Web interface to continue configuring the switch, the Web session is redirected to
the new management IP address. If the connection cannot be made, the J-Web interface
displays instructions for starting a J-Web session.
Connecting and Configuring a J-EX Series Switch (J-Web Procedure) on page 163
Installing and Connecting a J-EX4200 Switch
Installing and Connecting a J-EX8208 Switch
Installing and Connecting a J-EX8216 Switch
There are two ways to connect and configure a J-EX Series switch: one method is through
the console using the CLI and the other is using the J-Web interface. This topic describes
the J-Web procedure.
To access the J-Web interface, your management device must have the following software
installed:
Operating system: Microsoft Windows XP Service Pack 3
Browser version: One of the following. Other browsers might work but are not supported
by J-Series platforms.
Microsoft Internet Explorer version 7.0
Mozilla Firefox version 3.0
Additional requirements:
Only English-language browsers are supported.
The browser and the network must be able to receive and process HTTP/1.1 gzip
compressed data.
NOTE: Before you begin the configuration, enable a DHCP client on the
management PC you will connect to the switch so that the switch can obtain
an IP address dynamically.
NOTE: Read the following steps before you begin the configuration. You
must complete the initial configuration using EZSetup within 10 minutes. The
switch exits EZSetup after 10 minutes and reverts to the factory default
configuration, and the PC loses connectivity to the switch. The LCD displays
a count-down timer when the switch is in initial setup mode.
Chapter 15: Initial Configuration
163

Advertisement

Table of Contents
loading

Table of Contents