Replacing The Ph Heat Sink Fans (Ph Hsink Top And Ph Hsink Bot); Replacing The Psu Fans (Psu Ex R And Psu Ex L) - Christie CP2208-LP Service Manual

5. Remove the defective fan and guard from the mounting plate.
6. To install the new fan, complete these steps in reverse order.
Replacing the PH heat sink fans (PH HSINK TOP
and PH HSINK BOT)
The PH heat sink fans are located behind the exhaust skin and cool the light module.
Estimated time to replace: 21 minutes
1. Remove the exhaust panel skin (on page 38).
2. Disconnect the inline connector of the defective fan.
3. Remove the fan and fan guard from the mounting plate.
4. To replace the fan, complete these steps in reverse order.

Replacing the PSU fans (PSU EX R and PSU EX L)

The PSU fans are located behind the exhaust skin and cool the light module power supplies.
Estimated replacement time: 22 minutes.
1. Remove the exhaust panel skin (on page 38).
2. Remove the two screws securing the fan bracket.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Ventilation and cooling
54