Christie CP2208-LP Service Manual page 24

Screen/screw
Do not apply excessive force on the adjustment screws. This might cause the convergence adjustment
to become misaligned after you remove the adjustment tool.
The physical layout of the formatter boards determines the behavior of the twist and vertical
adjustments:
• The vertical adjustment screw and twist adjustment screw interact with each other such that if
one is turned in the opposite direction of the other, the twist is affected.
• If both screws are turned equal amounts in the same direction, the image moves vertically.
• The horizontal adjustment screw is independent of the vertical and twist adjustments.
You do not always have to turn the screws simultaneously. However, if you adjust one screw at a time
you will need to complete an equal or equal and opposite turn on the other screw to prevent binding
and to achieve the correct adjustment.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
A
N/A
N/A
B
N/A
N/A
Service setups
C
N/A
N/A
N/A
N/A
24