Table of Contents
Advertisement
11. Adjust the fold mirror a second time.
12. Straighten the bottom line of the test pattern using the light module adjuster wheels.
13. Move the L1 lens again until the corners and edges of the test pattern are sharp.
14. Tighten the lens screws but not fully.
15. Adjust the fold mirror a third time, until you get a maximum screen size and all four corners of
the screen are fully lit.
16. Adjust the front of the light module up and down with the adjuster wheel closest to the lens, to
shift the light left and right.
17. Tighten the locking bolt (G) at the front of the light module.
18. Tighten the right-side locking screw (I) at the rear of the light module.
19. Tighten the left-side locking screw (H) at the rear of the light module.
20. Fully tighten the L1 lens screws.
21. Quarter-turn each light module bracket screw (A-F) until the brackets are secured in place.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Optics
75
Hide quick links:
Advertisement
Table of Contents
