Service Setups; Turning The Projector On; Turning The Projector Off; Adjusting The Fold Mirror - Christie CP2208-LP Service Manual

Service setups

Understand the special internal hardware and software adjustments and related details that may
require the attention of a qualified service technician, whether done periodically or after a specific
module replacement.

Turning the projector on

The projector is turned on using the touch panel controller (TPC).
Warning! Failure to comply with the following could result in death or serious injury.
• SHOCK HAZARD! Do not attempt operation if the AC supply is not within the specified voltage
and power range, as specified on the license label.
1. Ensure that the circuit breaker for the projector is on.
2. On the TPC, tap and hold the green power ( ) icon.

Turning the projector off

Complete the following procedure to turn off the projector.
1. On the touch panel controller (TPC), to turn the light source off, tap and hold the light off
( ) icon.
2. Tap and hold the power off (
The projector enters a cool down mode and the fans and electronics stay on for 5 minutes.
After this cool down period, the projector enters standby mode.
3. If you are servicing the projector or removing the protective cover, disconnect the AC power
and turn the breaker off.

Adjusting the fold mirror

Learn how to align the fold mirror with the optical system to correct an image with missing or
shadowy corners or edges.
1. Remove the top skin. (on page 32)
2. Display the RGB-12bit-Full Screen White test pattern. (on page 87)
3. Note the location of the following screws:
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
) icon.
16