Christie CP2208-LP Service Manual page 77

7. Disconnect the shutter assembly harness.
8. Disconnect the SAMTEC cables from the backplane board.
9. Remove the SAMTEC cables from the harness clips holding them to the center structure.
10. Attach the service handle (A) to the light engine (B).
11. Loosen the three captive screws securing the light engine to illumination optic system (IOS)
assembly.
12. Remove the light engine.
13. Remove the shutter assembly by removing the two screws securing the shutter bracket to the
new light engine.
14. To replace the light engine assembly, complete these steps in reverse order.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Optics
77