Christie CP2208-LP Service Manual page 28

Item Description
• ICP—The LED is green when the ICP is operating correctly. A red LED indicates a communication
issue. If the LED is not illuminated, the ICP is inactive.
• IMB—The LED is green when the integrated media block (IMB) is operating correctly. A red LED
indicates a communication issue. If the LED is not illuminated, the IMB is inactive.
E Indicates marriage status. In full power mode, a green LED indicates that the projector is properly
married and encrypted content can be displayed. A red LED indicates marriage is broken and
encrypted content cannot be displayed.
F Turns the projector and the lasers on and opens the douser. Press and hold the button to close the
douser, turn the lasers off, and keep the power on. We recommend that you use this button only when
the TPC is unavailable.
G Resets the projector electronics. After restarting, the projector returns to its previous power mode.
You must turn on the light source manually.
H Connects the projector to 3D devices.
I Connects the projector to Christie or third-party automation equipment.
J Connects the projector to a 10Base-T/100Base-TX Ethernet connection.
K Connects the projector to high-definition cinema sources. The connectors can be used together to
deliver Dual Link HD-SDI following the SMPTE 372M standard.
L Connects the projector to the building fire alarm so the light source can be shut down in the event of
a fire. If you are not using the connection, leave the factory installed jumper cable in place.
Wire the fire alarm circuit on the projector to a normally closed, dry contact building fire alarm circuit.
When the contacts open, the light source shuts down and cannot be turned back on until the circuit is
closed and a light on command is sent to the projector.
We recommend using twisted pair wiring, minimum 24 AWG. The circuit should be left floating, do not
connect to ground.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright 2016 Christie Digital Systems USA Inc. All rights reserved.
©
Service setups
28