2. Loosen the two captive screws on the cap plate and remove it.
3. Slide the air filter out and inspect it.
•
If the filter appears dirty and you cannot see through it, clean it (on page 45).
•
If the filter appears clean, continue to step 4.
4. Replace the air filter with the airflow indicator facing toward the projector.
5. Install the cap plate and tighten the two captive screws.
6. Install the service access door and tighten the two captive screws.
Inspecting the rear radiator filter
The rear radiator filter is located at the rear of the projector, next to the radiator assembly.
1. Loosen the two screws on the filter cover and remove it.
CP2208-LP Service Manual
020-102263-01 Rev. 1 (09-2016)
Copyright
2016 Christie Digital Systems USA Inc. All rights reserved.
©
Filtration
44