Servicing Server Node Cables - Oracle Database Appliance X7-2M Service Manual

See the Oracle Database Appliance Owner's Guide for instructions.
b. Reconnect the power cords to the system and power on the system.
See "Powering On Oracle Database Appliance Version 1" on page

Servicing Server Node Cables

Information in this appendix does NOT apply to Oracle Database Appliance X3-
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section includes information on servicing cables in Oracle Database Appliance Version 1.
The internal server node cables are FRUs and can only be replaced by an Oracle-qualified
service technician.
Equipment damage. These procedures require that you handle components that are
Caution -
sensitive to static discharge. This sensitivity can cause the component to fail. To avoid damage,
ensure that you follow antistatic practices as described in
and Antistatic Prevention Measures" on page
The following topics are covered in this section:
"Servicing the Fan Power Cables (FRU)" on page 227
■
"Servicing the PCIe Card Cables (FRU)" on page 230
■
"Servicing the SAS Expander Cable (FRU)" on page 235
■
"Servicing the Boot Disk Backplane Cables (FRU)" on page 237
■
Servicing the Fan Power Cables (FRU)
Each Oracle Database Appliance Version 1 server node has two fans and each fan has a separate
power cable.
"Performing Electrostatic Discharge
146.
Appendix A • Servicing the Oracle Database Appliance Version 1
Install Front Indicator Panel
249.
227