Oracle Database Appliance X7-2M Service Manual page 25

Callout Indicator/LED: Color
3 OK: green
4 Power button
5 Top fan: amber
6 Rear PS: amber
7 Over temperature warning:
amber
8 Service processor (SP): green
9 Drive OK: green
10 Drive Service Required: amber
11 Drive Ready-to-Remove: blue
Oracle Database Appliance X6-2S/X6-2M/X6-2L Status Indicators
State Meaning
Note - The lighting of this indicator is always accompanied by a
system console message that includes a recommended service action.
Indicates the operational state of the server node:
■ On – The server is powered on, and all host POST code
checkpoint tests are complete. The server is in one of the
following states: 1) the server host is booting the operating
system (OS), 2) the server host is running the OS.
■ Off – AC power is not present or the Oracle ILOM boot is not
complete.
■ Steady blink – Standby power is on, but the chassis power is off
and the Oracle ILOM SP is running.
■ Slow blink – Startup sequence has been initiated on the host.
This pattern should begin soon after you power on the server.
This status indicates either: (1) POST code checkpoint tests are
running on the server host system, or (2) the host is transitioning
from the powered-on state to the standby state on shutdown.
Press to apply full power. Press again to turn main power off, but
leave standby power on the Oracle ILOM.
Indicates that one (or more) of the internal fan modules has failed.
■ Off – Indicates steady state; no service is required.
■ On – Indicates service required; service the failed fan module.
Indicates that one (or more) of the power supplies has failed.
■ Off – Indicates steady state; no service is required.
■ On – Indicates service required; service the failed power supply.
■ Off – Normal operation; no service is required.
■ On – The system is experiencing an over temperature warning
condition.
Note - This is a warning indication, not a fatal over temperature.
Failure to correct this condition might result in the system
overheating and shutting down unexpectedly.
■ Off – The service processor (SP) is not running.
■ On – The SP is fully operational.
■ Slow blink – SP is booting.
■ Off – Power is off or the installed drive is not recognized by the
system.
■ On – The drive is engaged and is receiving power.
■ Random blink – There is disk activity. The indicator blinks on
and off to indicate activity.
■ Off – The storage drive is operating normally.
■ On – The system has detected a fault with the storage drive.
■ Off – The storage drive has not been prepared for removal.
■ On – The storage drive can be removed safely during a hot-plug
operation.
Chapter 1 • Overview of System Status Indicators and LEDs 25