Oracle Database Appliance X7-2M Service Manual page 220

Remove Disk Midplane Module HDD Cable
The following topics are covered in this section:
"Remove Disk Midplane Module HDD Cable" on page 220
■
"Install Disk Midplane Module HDD Cable" on page 221
■
Remove Disk Midplane Module HDD Cable
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing the disk midplane module HDD cable from Oracle Database
Appliance Version 1.
Prepare the system for service.
1.
a. Power off the system.
See
Disconnect the power cords from the system.
b.
c. If the system is installed in a rack, remove it.
See the Oracle Database Appliance Owner's Guide for instructions.
Attach an antistatic wrist strap.
d.
See
Measures" on page
Remove the middle section of the system top cover.
2.
See "Removing the Middle Section of the System Top Cover" on page
3. Disconnect the HDD ribbon cable connector located on the power distribution
board [1]).
220 Oracle Database Appliance Service Manual • November 2017
Information in this appendix does NOT apply to Oracle Database Appliance X3-
"Shutting Down a Server Node and Powering Off the System" on page
"Performing Electrostatic Discharge and Antistatic Prevention
146.
143.
150.