Server Node Basic Input/Output System (Bios) - Oracle Database Appliance X7-2M Service Manual

a.
b.
c.

Server Node Basic Input/Output System (BIOS)

Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes the Oracle Database Appliance Version 1 BIOS utility. If you have
Oracle Database Appliance X6-2 series, go to
Utility" on page
X4-2, or Oracle Database Appliance X5-2, go to
BIOS Utility" on page
This section describes the Oracle Database Appliance Version 1 BIOS utility.
All settings are set to the optimal defaults at startup.
Caution -
software will do this for you. The only time you might need to configure BIOS settings would
be if requested to do so by Oracle Service.
The following topics are included:
"BIOS Booting and Setup" on page 252
■
"Configuring Support for TPM" on page 260
■
"Configuring SP LAN Settings" on page 266
■
Log in to Oracle ILOM using an ssh client. Type:
$ sp_ip_address
ssh username@
Where username is a user account name with Reset and Host Control (r) privileges
and sp_ip_address is the IP address of the server node service processor.
When prompted, enter the user account password.
Enter the command to power on the server node:
->
start /SYS
On the server node, the green Power/OK LED [2] blinks while the server node is
booting, and remains steady on when the server node is operational.
Information in this appendix does NOT apply to Oracle Database Appliance X3-
135. If you have Oracle Database Appliance X3-2, Oracle Database Appliance
136.
You should not configure system BIOS settings. Oracle Database Appliance patch
Server Node Basic Input/Output System (BIOS)
"Oracle Database Appliance X6-2 Series BIOS
"Oracle Database Appliance X3-2/X4-2/X5-2
Appendix A • Servicing the Oracle Database Appliance Version 1 251