Servicing Fan Modules (Cru) - Oracle Database Appliance X7-2M Service Manual

3. Slide the drive into the drive slot until it is fully seated [1].
Close the drive latch to lock the drive in place.
4.
Close the drive door and ensure that the door latch engages [2].
5.
Equipment damage. Close the door after removing a boot drive to prevent
Caution -
overheating due to improper airflow.
Run the following command to ensure that the OS sees the replacement disk.
6.
# lsscsi -v | grep ATA
[0:0:0:0]diskATA SEAGATE ST95001N n/a
[1:0:0:0]diskATA SEAGATE ST95001N n/a

Servicing Fan Modules (CRU)

Information in this appendix does NOT apply to Oracle Database Appliance X3-
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
Each Oracle Database Appliance Version 1 server node contains two fan modules. Each fan
module contains a single, dual-motor, 80 mm, counter-rotating fan assembly that contains two
/dev/sda
/dev/sdb
Appendix A • Servicing the Oracle Database Appliance Version 1
Install a Boot Drive
159