Returning Oracle Database Appliance Version 1 To Operation - Oracle Database Appliance X7-2M Service Manual

Log in to the Oracle ILOM command-line interface (CLI), and type the following command
■
at the Oracle ILOM CLI prompt.
->
When the server is powered on and the power-on self-test (POST) code checkpoint tests have
completed, the green Power/OK status indicator on the server node front panel lights and
remains lit.
Note -
the second server node.
Refer to other Oracle Database Appliance documentation for any instructions or
5.
commands required to return the appliance to service.
Refer to the appropriate Deployment and User's Guide for the Oracle Database Appliance
X7 series and X6 series, or the Administration and Reference Guide for the Oracle Database
Appliance X3-2/X4-2/X5-2 or Oracle Database Appliance Version 1.
Returning Oracle Database Appliance Version 1 to
Operation
This section describes returning Oracle Database Appliance Version 1 to operation after
servicing.
If you have Oracle Database Appliance X7-2 series, go to
Appliance X7-2 Series to Operation" on page
Appliance X6-2 series, go to
Operation" on page
"Returning Oracle Database Appliance X3-2/X4-2/X5-2 to Operation" on page
"Installing the Server Node Top Cover" on page 245
■
"Installing a Server Node Into the System Chassis" on page 246
■
"Powering On Oracle Database Appliance Version 1" on page 249
■
start /SYS
If you powered off both server nodes prior to servicing, repeat steps 3 and 4 to power on
"Returning Oracle Database Appliance X6-2 Series to
124. If you have Oracle Database Appliance X3-2/X4-2/X5-2, go to

Returning Oracle Database Appliance Version 1 to Operation

"Returning Oracle Database
123. If you have Oracle Database
Chapter 6 • Returning Oracle Database Appliance to Operation
125.
127