Oracle Database Appliance X7-2M Service Manual page 157

3. Close the latch to lock the drive in place.
4.
Run the fwupdate command and verify that it lists all the disks under the DISKS
section.
Remove a Boot Drive
Information in this appendix does NOT apply to Oracle Database Appliance X3-
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes removing a boot drive from Oracle Database Appliance Version 1.
1. Identify the boot drive that you want to remove.
The amber Service Required LED might be lit. For specific drive locations, see
Boot Drive Locations" on page
Remove the boot drive.
2.
To open the drive door, slide the latch to the left.
a.
b. Pull the door open [2].
c. On the drive you plan to remove, push the storage drive release button to
open the latch [2].
d. Grasp the latch and open it to a 45 degree angle [2].
Using the latch, slowly pull the drive straight out of the drive slot, not
e.
sideways or vertically [2].
Do not use much force on the latch when removing the drive.
Equipment damage. Do not use the latch as an ejector. Do not bend it too far to the
Caution -
right.
153.
Appendix A • Servicing the Oracle Database Appliance Version 1
Remove a Boot Drive
"Storage and
157