Servicing Frus - Oracle Database Appliance X7-2M Service Manual

1. Unpack the replacement battery.
2. Press the new battery into the battery holder with the positive side (+) facing the
server node side wall.
3. If the service processor is configured to synchronize with a network time server
using the Network Time Protocol (NTP), the Oracle ILOM clock is reset as soon
as the server node is powered on and connected to the network. Otherwise,
proceed to the next step.
If the service processor is not configured to use NTP, you must reset the Oracle
4.
ILOM clock using the Oracle ILOM CLI or the web interface.
For instructions, see the Oracle Integrated Lights Out Manager (Oracle ILOM) 3.0
Documentation Collection.
Return the server node to operation.
5.
a. Install the server node top cover.
See
b. Install the server node into the system.
See
Power on the server node.
c.
See

Servicing FRUs

This section describes how to service server node FRUs for Oracle Database Appliance Version
1. If you have Oracle Database Appliance X6-2 series, go to
Appliance X6-2 Series FRUs" on page
Oracle Database Appliance X4-2, or Oracle Database Appliance X5-2, go to
Database Appliance X3-2/X4-2/X5-2 FRUs" on page
Note -
"Removing and Installing the Air Duct (FRU)" on page 194
■
"Servicing Processors (CPUs) (FRU)" on page 197
■
"Servicing the Boot Disk Backplane (FRU)" on page 204
■
"Install Server Node Top Cover" on page
"Install Server Node Into System Chassis" on page
"Powering On Oracle Database Appliance Version 1" on page
Only Oracle authorized service personnel should service FRU components.
246.
108. If you have Oracle Database Appliance X3-2,
118.
Appendix A • Servicing the Oracle Database Appliance Version 1
Servicing FRUs
247.
249.
"Servicing Oracle Database
"Servicing Oracle
193