Installing A Server Node Into The System Chassis - Oracle Database Appliance X7-2M Service Manual

Install Server Node Top Cover
Install Server Node Top Cover
Note -
2, Oracle Database Appliance X4-2, Oracle Database Appliance X5-2 or Oracle Database
Appliance X6 series. Refer to the preceding chapters in this document for information on
servicing those systems.
This section describes installing the server node top cover for Oracle Database Appliance
Version 1.
Place the top cover down on the server node so that it hangs over the front of
1.
the chassis by 0.5 inches (12.7 mm).
Ensure that all six of the standoffs on the underside of the cover (three on each
2.
side) fit into the slots on the top of the chassis side walls.
When the top cover is positioned (as described in previous step), the six standoffs on the
underside of the cover fit into the slots in the top of the chassis sidewalls.
Slide the top cover toward the rear of the server node until it seats [2].
3.

Installing a Server Node Into the System Chassis

If you removed a Oracle Database Appliance Version 1 server node from the chassis, perform
the following procedure to reinstall it.
246 Oracle Database Appliance Service Manual • November 2017
Information in this appendix does NOT apply to Oracle Database Appliance X3-