Table of Contents
Advertisement
Configuring X.25
Configuring X.32 profiles for incoming switched X.25 connections
Net2Net circuit mode
With traditional X.25 connections, you configure one X.25 switched connection per client, as
in Figure 6-3.
Figure 6-3. Traditional X.25 connection
But a MAX 6000 unit can enable several X.25 clients to share a single connection to an X.25
network. In Figure 6-4, the X.25 switch connects to the MAX 6000. The X.25 switch sees the
MAX 6000 as a terminating device—Data Terminal Equipment (DTE). The clients see the
MAX 6000 as an X.25 switch—Data Communications Equipment (DCE).
Figure 6-4. Net2Net circuit mode
X.25 switch
To configure Net2Net circuit mode, proceed as follows for each client:
1
2
3
4
5
6
7
8
9
10 Set Call Type to Switched.
6-28
DCE
DCE
DCE
X.25 switch
Nailed X.25
DCE
DTE
Open the Ethernet > Connections > client's profile > X.32 profile.
Set Encaps to X.32.
Set Calling # to the client's number.
Set Called # to the number of the MAX ISDN line.
Set the Encaps Options > X.25 Prof parameter to the name of a profile in the Ethernet >
X.25 menu, that is, to the name of the X.25 profile to be used for this client.
Set the Appl Mode parameter to Net2Net.
Exit the profile and, at the exit prompt, select the
Open the Ethernet > X.25 profile to be used for this client.
Set Active to Yes.
sX.25
sX.25
sX.25
MAX 6000
sX.25
DCE
DTE
exit and accept
MAX 6000/3000 Network Configuration Guide
DTE
Client
DTE
Client
DTE
Client
DTE
Client
Client
option
.
Advertisement
Table of Contents
