Routing Calls On The Basis Of Called Number - Lucent Technologies MAX 6000 Network Configuration Manual

Routing calls on the basis of called number

Figure 3-5 shows an example of a MAXDAX installation.
Figure 3-5. Sample MAXDAX (T1) installation
On MAX 1, T1 Drop and Insert enables users connected to the PBX to make and receive calls.
The system administrator configures MAXDAX on MAX 2.
The system administrator uses Answer Plan profiles to direct incoming calls to the PRI line,
and therefore does not change any of the parameters in the Net/T1 > Line Config > Line Config
profile > Line N > Net2Net Incoming Calls profile from their default settings:
Net/T1
Line Config
To reach Video System C, a user dials the number (617) 555-1212. MAX 2 should only
redirect to the PRI line any calls received with a called number of 6175551212. The system
administrator configures the Answer Plan profile as follows:
MAX 6000/3000 Network Configuration Guide
Video System A
Serial line
T1
Pipeline 75
PBX
Line Config profile
Line 1...
Net2Net Incoming Calls
Ch 1=Switched
Ch 1 Dest ChanGroup=1
Ch 1 Dial Plan #=0
Ch 1 #DialPlanSelDigits=2
Ch 2=Switched
Ch 2 Dest ChanGroup=1
Ch 2 Dial Plan #=0
Ch 2 #DialPlanSelDigits=2
Ch 3=Switched
Ch 3 Dest ChanGroup=0
Ch 3 Dial Plan #=0
Ch 3 #DialPlanSelDigits=0
MAX 1 MAX
Leased T1
Video System B
Configuring WAN Access
Configuring MAXDAX
Video System C
2
PRI
PSTN
Serial line
3-83