Table of Contents
Advertisement
FXS line profiles
There are five possible slot profiles for each MAXPOTS slot card. The first profile (default) is
always the active profile. You can save alternative configurations in the other four profiles.
Configuring an FXS line profile
To configure a slot (or line) profile in Main > Analog FXS > FXS Config > FXS Configuration
profile > Line profile, use the following parameters:
Parameter
Name
Dial-Enabled
Inc CallerID Info
Clid Number
Answer-Enabled
CallerID
Forward Disc
Rx Gain
Tx Gain
Signalling
GndStart Ring
Saving alternative configurations
To copy the active profile to one of the alternate live profiles, proceed as follows:
1
2
3
4
Activating an alternative profile
To activate one of the alternative profiles, copy any alternative profile to the active profile,
proceed as follows:
1
MAX 6000/3000 Network Configuration Guide
Configuring POTS capability on the MAX 6000 and MAX 3000
Specifies
Name of the profile.
Enable/disable outbound dialing through this profile's POTS port.
Include/do not include CallerID information for calls from this port.
Telephone number of the caller.
Enable/disable answering of calls on this profile's POTS port.
Do/do not forward caller-ID information to the POTS port. MAXPOTS
only supports the Bellcore Type I callerID format which might not be
supported in all countries.
Far-end disconnect indication is/is not forwarded to the POTS port.
Gain applied to the signal received from the connected equipment.
Gain of the signal transmitted to the equipment.
The signaling used on an analog loop. Regular telephones use Loopstart.
Apply/do not apply ringing voltage to the ground start line.
From Analog FXS > FXS Config, select the active profile.
The active profile appears.
Press Ctrl-D to access the DO menu.
The DO menu appears.
Select S (Save).
Select the alternate live profile by using the Up Arrow and, Down Arrow keys, and press
Enter.
The active profile is saved to the specified alternative profile.
From Analog FXS > FXS Config, select the alternative (101, 102, 103, or 104) profile you
want to activate.
Configuring Individual WAN Connections
4-101
Advertisement
Table of Contents
