Lucent Technologies MAX 6000 Network Configuration Manual page 497

Configuring IPX Routing
Configuring IPX routing connections
10 Exit the profile and, at the exit prompt, select the exit and accept option.
Configuring the MAX at Site B
On the MAX at Site B:
1
2
3
4
5
12-16
Server Type=0004
Connection #=5
Following is a comparable RADIUS profile:
ipxroute-max-1 Password = "ascend", Service-Type = Outbound-User
Ascend-IPX-Route="sitebgw 013DE888 000000000001 0451 0004
SERVER-2"
Note: The Connection # parameter in the IPX Route profile must match the number of
the Connection profile you configured for that site. If you specify the internal network
number of a server, make sure you specify values for Server Name and Server Type. If you
specify an external network, do not specify a value for Server Name or Server Type.
Assign the MAX unit a system name in the System > Sys Config profile. This example
uses the name SITEBGW.
Verify that the Site B MAX unit's Ethernet interface has a configuration defined for IPX
routing. (For instructions, see "Enabling IPX routing in the MAX" on page 12-5.)
Verify that the Site B MAX unit's Answer > PPP Options profile enables IPX routing and
PAP/CHAP authentication.
Open the Connection profile for Site A.
In this example, the Connection profile for Site A is profile #2. A profile's number is the
unique part of the number you assign in the Connections menu. For example, the
Connection profile defined as 90-102 is #2.
Set up the Connection profile as follows:
Ethernet
Connections
90-102 #2...
Station=SITEAGW
Active=Yes
Encaps=MPP
PRI # Type=National
Dial #=555-1213
Route IPX=Yes
Encaps options...
Send Auth=CHAP
Recv PW=*SECURE*
Send PW=*SECURE*
IPX options...
IPX RIP=None
IPX SAP=Both
NetWare t/o=30
SAP HS Proxy=N/A
SAP HS Proxy Net#1=N/A
SAP HS Proxy Net#2=N/A
SAP HS Proxy Net#3=N/A
SAP HS Proxy Net#4=N/A
SAP HS Proxy Net#5=N/A
SAP HS Proxy Net#6=N/A
MAX 6000/3000 Network Configuration Guide