Table of Contents
Advertisement
11 To define an additional address pool for dynamic address assignment, set the IP Group 2
12 Set the Group 2 Count parameter to the number of addresses in the pool. The second pool,
13 To reserve an IP address for a particular host, set the Host 1 IP parameter to the IP address
14 Set the Host 1 Enet parameter to the MAC (Ethernet) address of the host. The MAC
15 To reserve an IP address for another host, set the Host 2 IP parameter to the IP address for
16 To reserve an IP address for another host, set the Host 3 IP parameter to the IP address for
Setting up a DHCP server
To set up a DHCP server, set these required parameters:
DHCP Spoofing
DHCP Spoofing=Yes
Always Spoof=Yes
IP group 1=nnn.nnn.nnn.nnn/nn
Group 1 count=n
Additionally, you can set these parameters:
Renewal Time=nn
IP group 2=0.0.0.0/0
Group 2 count=0
Host 1 IP=nnn.nnn.nnn.nnn/nn
Host 1 Enet=0080c75Be95e
Host 2 IP=0.0.0.0/0
Host 2 Enet=000000000000
Host 3 IP=0.0.0.0/0
Host 3 Enet=000000000000
Setting up Plug and Play support
To set up Plug and Play, you must set the following parameters:
DHCP Spoofing
DHCP Spoofing=Yes
DHCP PNP Enabled=Yes
Setting up DHCP spoofing
To set up DHCP spoofing, you must set the following parameters:
MAX 6000/3000 Network Configuration Guide
parameter to the first address for the second IP address pool.
which can also contain up to 20 addresses, is used only if there are no addresses available
in the first pool.
for the host.
address is normally the Ethernet address of the network interface card that the host uses to
connect to the LAN. When the DHCP server receives an IP-address request from the host
with this MAC address, it assigns that host the IP address you specified for the Host 1 IP
parameter.
the host and set the Host 2 Enet parameter to the MAC (Ethernet) address of the host.
the host and set the Host 3 Enet parameter to the MAC (Ethernet) address of the host.
Configuring Individual WAN Connections
Configuring DHCP services
4-99
Advertisement
Table of Contents
