Table of Contents
Advertisement
channel you configure, the Ch N parameter to Switched and the Ch N ChanGroup parameter to
a value from 1–65536. These parameters function as follows:
Parameter
Ch N
Ch N ChanGroup
When finished configuring channels, save these changes, and exit the profile.
If the profile you have configured is not the active profile, activate it as described in
"Activating a profile" on page 2-7.
Configuring channels on which the MAX unit receives calls
To configure a channel on which the MAX unit receives incoming calls, you must specify a
destination channel-group. When the unit receives a call, it makes an outgoing call on the first
available channel assigned to the destination channel-group number you specify. You can
assign any number of channels to a channel group.
Note: Make sure you do not direct the unit to make an outbound call on the same channel on
which it receives the call.
If you configure the unit to use direct mapping, a specific Dial Plan profile, or a caller-defined
Dial Plan profile, you must set some or all of the following parameters:
Parameter
Ch N
Ch N Dest ChanGroup
Ch N Dial Plan #
Ch N #DialPlanSelDigits
You set additional parameters if you configure an Answer Plan profile.
MAX 6000/3000 Network Configuration Guide
How it's used
N is a number representing a channel. For each channel used for
outbound calls, you must set Ch N to Switched, or MAXDAX does not
function.
Assigns channel to a group. When the MAX unit receives a call, it
compares the value of the Ch N Dest ChanGroup parameter of the
incoming channel to the value of the Ch N ChanGroup parameters of
the available outgoing channels, and places the call on the first
outgoing channel that matches.
How it's used
N is a number representing a channel. For each channel you
configure for incoming calls, you must set Ch N to Switched, or
MAXDAX does not function.
Specifies the channel-group number to which the unit directs the
outgoing call. You assign channels to groups, to be used for
outgoing calls, by setting the Net/T1 (E1) > Line Config > Line
Config profile > Line N > Net2Net ChanGroup ID > Ch N
ChanGroup parameter.
Specifies a Dial Plan profile the unit applies to calls received on
this channel.
Specifies the number of leading digits the unit strips from the
called number. The unit uses stripped digits to determine the Dial
Plan profile to use for the received call.
Configuring WAN Access
Configuring MAXDAX
3-77
Advertisement
Table of Contents
